PRODUCTS
- Aluminum Foil Packaging
- Flexible Packaging
- Plastic Film Packaging
-
new category
- Ungrouped
- Shrink Film
- Sealing/Lidding Film(For cup/tray)
- Laminated Roll Film
- Plastic Film Products
- Aluminum Chocolate Wrapping Foil
- Aluminum foil paper
- Greaseproof Paper Bag
- Side Gusseted Pouch
- Flat Bottom Pouch
- Coffee Bag
- Hot Seal Bag
- Microwave Popcorn Bag
- Greaseproof Paper
- Food Wapping Paper
- Twist Film
- Heat Sealable Film
- Butter Wrapper
- Aluminum Foil Products
- Stock bag
- Kraft Paper Bag
- Stand Up Pouch / Doypack
- Three Side Sealed Bag
- Metalized Stand Up Pouch
- Flexible Packaging Products
Plastic packaging waste Angle edge material - Packaging printing
by:Kolysen
2020-06-29
In most of the thermosetting plastic moulding process, always there will be a redundant spilled material, known as the flash, the flash is usually appear in the parting surface or touch them, out of respect for the surface quality of the products, or for the plastic seal electronic components contact and assembly, often to the edge of the operation is necessary.
If you want to further enhance the flash effect, the rolling movement at the same time, the container can be placed in the container some mutual friction material more easily.
【
Packaging printing 】
Custom message