Bag making machine several common problems and treatment measures

Bag making machine is used for making all kinds of plastic composite packaging machines, packaging or other material thickness of its scope of processing various sizes of the packing bag of different specifications of plastic or other materials. Of course, in the process of the use of bag making machine, also can appear many problems, this article is to help you eliminate those about bag making machine use failure problems. 1, the flat machine cold knife cut constantly to do when the flat machine cold knife always cut constantly, to check whether the knife is sharp, whether to need to grind; Check whether the knife up and down balance right, knife block to use for a long time, wear a clearance, will cause imbalance. 2, the flat machine cut three or more, the bag size different length to do after that a thin membrane mat layer on the rubber roller, can with other materials evenly. 3, the flat machine spring is broken, what is the cause of article since the glue does not stick in place, become warped up in spring, spring will be broken, in the operation must stick adhesive article is good. There is a reason, the material is not neat or folded into the rubber roller, lead to inefficient spring break. 4, bone bag bag making machine sealing side large difference of both sides to do aluminum roller debugging good, must be transferred to the sealing side pressure on both sides, will avoid this situation. Article 5, edge sealing machine cut adhesive article often stick to the conveyor belt is the reason why the stick, stick to the conveyor belt, you need to machine the back of the display of the stick a good debugging, stick straight edge magic eye must be put in the straight edge, prevent movement. 6, OPP have burrs or blast while cutting rot is what reason not good, hot knife and the suction arm is normal hot knife down up to 2 cm, absorb arm again sent out the material. 7, edge sealing machine cut out products different length to do pressure spring pressure lead to rubber roller slippage, or at the back of the splint clip too loose or too tight, need to debug to the right. 8, the flat machine appeared in front of the cold knife plugging material do appear this kind of circumstance should be bag electronics is too strong, application of rubber band put a piece of small paper posted on knife beam screw, cut out the tape at the same time card on the out of the bag. 9, blown film machine discharging winding thickness uneven, both side do need on one side of the thin thin on electronic frame around a circle to the right. 10, printing bag feeding is not smooth, magic eye is not sensitive to do first check magic eye have used correctly, magic eye for color sensitive reaction. If the bag is monochromatic use blue, heavy color with red, red can be used for monochrome and color. Straight edge machine of the roller under the magic eye to jet black, if the single and the heavier bag color with white best. 11, xinji no bag long, cutting knife cut thin composite film, or a certain place and how to do this kind of situation, may be because the knife beam on the slider over a period of time after running-in, slider and copper pad gap is too big, causing the cutting knife cutting continuously. The top of the copper pad can be adjusted seam ( M6 inside) , to adjust to use knife beam on hand did not move the slider, but it cannot be transferred to too tight. Boot cut 15 per minute & ndash; On 20 zhang, knife beam no obvious shaking just prove clearance elastic. In addition to knife beam spring pressure can be adjusted. 12, flat machine, R sealing is not strong to do (1) check whether there is hot knife caton: hot sealing and cutting knife is not smooth sometimes causes the sealing strong, sometimes is not strong. (2) check whether the blade is because of the heat deformation, bending. Check method is exactly a hot knife rotation, as the hot knife just wanted to come into contact with the silica gel roller or silica gel plate, through the transmission method determine hot knife without buckle, such as bending, fixed blade flatness (3) check whether film electronics is too strong, with no smoke a pack of electronic film test, a sealing and cutting the see the sealing have obvious changes, if yes, proved that the roll of film electronics is too strong, suggested in a coil.