Solar energy new technology application in flexible packaging maturation

In the traditional soft packing curing room heating system, the main is given priority to with the traditional electric heating, the traditional electric heating, large energy consumption, low conversion rate, generally speaking, the average per square meter requires about 1 kw of power, and there is also easy to uneven heating problem. Therefore, looking for alternative sources of energy, reducing energy consumption, have been constant pursuit of packaging. Inside the industry waste heat in use, some innovations, such as ultraviolet radiation heating. However, these alternative heating system prone to solvent residue increased risk. At the same time, there may be a good effect at first, and save energy, but as time extended, the energy conversion is becoming more and more attenuation, finally the results of the energy consumption is becoming more and more big. One, the characteristics of curing chamber system curing chamber system is south JingZhao kay pioneering high efficiency and energy saving projects. It two application of solar heating and nano heating system, temperature alternating with system, to ensure that plastic products constant temperature 50 ℃ ~ 55 ℃ in 48 h. Throughout the year can save electric energy 60% above. The system is the use of solar energy hot water heating, and automatic control system will be hot water through the pipe to the curing room, again through the radiator to heat, drying curing on products. Or water tank temperature at night can't make the environment temperature, the device will start heating system control dry nano heater to heat curing chamber. Heater adopting international advanced nano energy efficient heating technology, compared with the ordinary electric heating, heating speed is faster, more significant effect of energy saving, safety performance is higher. Second, the application of curing chamber system in the sun, the sun can be the temperature of the water heated to ninety degrees, and then through the tubes to the curing room, then can reach more than seventy degrees temperature. But we need for the highest temperature of soft packing curing room just 50 degrees or so, this is where the induced by temperature control system, according to the set of automatic temperature control, control the transmission of heat pump hot water switch, to control the temperature. When the water temperature to reach the set temperature, the system automatically converted to dry nano heater, temperature heating temperature to the enterprise need, curing of finish of the product. The whole process can be controlled automatically, without manual operation. At night, when starting and ending time by setting, using off-peak by nano heater to heat water tank of cold water, so you can at the time of peak electricity use hot water curing of product water tank, thus played the effect to reduce costs. The system compared with the traditional electric heating, if there is sufficient sunshine, can all day don't need electricity, use hot water could reach the product drying curing. In use at the same time, can let the product is heated evenly and curing effect is better.